Filter
Top Products
Burn, Electrlcal Shock and Fire Hazard
l Make
sure all surface units are OFF betore replaclng surface units and
reflector bowls. Fallure to do so can result In burns or electrical shock.
l
Do not llne the reflector bowls wlth foil. Flre or electrlcal shock could
result.
1. Turn off all surface units.
2. Line up openings in the reflector
bowl and notch in the trim ring
with the surface unit receptacle
and the element hold down clip.
3. Hold the surface unit as level as
possible with the terminal just
started into the receptacle. Push
the surface unit terminal into the
receptacle.
4. When terminal is pushed into the
receptacle as far as it will go, push
down the edge of the surface unit
opposite the receptacle. The ele-
ment hold down clip will keep the
surface unit from moving around.
NOTE: Reflector bowls reflect heat back to the utensils on the surface
unlts. They also help catch spills. When they are kept clean, they reflect
heat better and look new longer.
If a trlm rlng gets discolored, some of the utensils may not be flat enough,
or some may be too large for fhe surface unit. In elther case, some of
the heat that’s meant to go into or around a utensil goes down and heats
the trlm rlng. lhls extra heat can discolor it. See Cooking Guide for further
Informatlon.