Filter
Top Products
The electronic clock/oven controls
There are three parts in the clock/oven control
section:
-The display
-The command pads
-The Set Knob
Instructions for the oven control are covered on
the following pages. Read them carefully.
When you first plug in the range, the last time
of day set will show in the display. If, after you set
the clock (page 9) the display again shows the
last time of day set, your electricity was off for a
while. Reset the clock.
Display/clock
When you are not using the oven, this is an
accurate clock. When using the oven or Minute
Timer, the display will show the time, temperature
settings and what command pads have been
pressed.
When showing the time of day, the display will
show the hour and minutes.
When using the Minute Timer, the display
shows minutes and seconds in the following
sequence:
l
For settings from O-l minute 55 seconds, the
display will increase in 5-second increments and
count down each second.
l
For settings from 2-10 minutes, the display will
increase in l&second increments and count
down each second.
l
For settings from lo-60 minutes, the display will
increase in 1 -minute increments and count
down each second.
l
For settings from l-2 hours, the display will
increase in 5-minute increments and count
down each minute.
l
For settings from 2 hours-9 hours 50 minutes,
the display will increase in lo-minute incre-
ments and count down each minute.
When using Cook Time and/or Stop Time, the
display shows hours and minutes.
Command pads
The command pads tell the oven what to do and
in what order. A few examples:
-Clock/Set tells the oven you are going to set the
clock.
-Off/Clear tells the oven to turn off.
Each command pad (except Off/Clear) has its
own indicator. The indicator comes on when you
touch the command pad.
Set Knob
Once you’ve pushed a command pad to tell the
oven what you want it to do, you’ll use the Set
Knob to set a temperature or time. Turning the
Set Knob clockwise increases the number on the
display. Turning the Set Knob counterclockwise
decreases the number on the display.