Filter
Top Products
PART
WHAT
TO USE
HOW TO CLEAN
Single-edge razor blade in
a holder for hard to remove
soil.
Cook Top Polishing Creme’
(PN 814009) and a clean
paper towel.
Smoothtop
Module
Warm soapy water and
a soft cloth or paper towel.
Vinegar and clean paper
towel.
l
Wash, rinse and dry well.
l
Do not soak in water.
To clean COOL cooktop:
l
For stubborn stains, soak paper towel
with vinegar. Rub stained area.
If needed, keep vinegar soaked paper
towel on stain for IO-15 minutes.
Rub off soil.
l
Rinse and dry well.
‘To obtain order information,
write to:
l
Do not use vinegar on metal parts.
l
For soils not removed with other methods,
carefully scrape off the soiled area, then
use the above cleaning method.
l
For sugary spills, remove stain while
cooktop is still slightly warm. Remove
sugary spills immediately. Reheating may
cause glass to pit.
l
If desired, use Cook Top Polishing Creme
on
CLEAN
cooktop to add shine and reduce
further soiling and to remove metal marks.
l
Shake well and apply about% tablespoon
to clean cooktop. Rub and buff with clean
paper towel.
l
Remove metal marks as soon as possible.
If metal marks have been heated, removal
may not be possible.
Whirlpool Corporation
Attention: Customer Service Dept.
1900 Whirlpool Drive
LaPorte, lhi 46350
Area Under
Warm soapy water and
Modules
a soft cloth.
l
Wash, rinse and dry well.
l
Da not soak.
Control Panel
Warm soapy water or
spray glass cleaner
and a soft cloth.
l
Wash, rinse and dry well.
l
Do not pour water into the area.
l
Do not drip water into receptacles.
Control Knobs
Warm soapy water and
a soft cloth.
l
Wash, rinse and dry well.
l
Do not soak.
Cleaning the Vent System
Betore cleaning the vent system, turn the
fan and all controls to OFF.
1.
To clean, remove the vent grill and wipe
clean with a damp cloth or wash in warm
soapy water. Do not use metal scouring
pads or harsh cleansers. Do not place in
dishwasher.
2. Lift filters and turn slightly to remove. The filters
can be cleaned in warm soapy water or in
the dishwasher.
3. Wipe the vent box with a damp cloth to
clean. Spills should be sponged out.
4. Install filters, being sure they are angled over
the exhaust fan touching at the center.