Filter
Top Products
REPLACING
1.
Be sure surface unit controls are OFF.
\ Opening
Receptacle
/
2. Line up opening in the reflect& bowl and
notch in trim ring with the surface unit
receptacle.
3. Hold the surface unit as level as possible
with the terminal lust started into the
receptacle.
4. While pushing the surface unit terminal into
the receptacle, lift a little on the edge of
the unit nearest the receptacle
5. When the terminal is pushed into the re-
ceptacle as far as it will go, the surface unit
will fit into the reflector bowl
Reflector bowls reflect heat back to the
utensils on the surface units. They also help
catch spills. When they are kept clean, they
reflect heat better and look new longer.
If a trim ring gets discolored, some of the
utensils used may not be flat enough Or
some may be too large for the surface unit.
In either case, some of the heat that IS meant
to go Into or around a utensil goes down
and heats the trim ring. This extra heat can
discolor it
COOKTOP
1.
Be sure surface units and cooktop are cool.
2. Carefully lower the cooktop onto the
Lift the front of the cooktop at the center
support rod. Be sure the tip of the rod fits in
and swing the support rod up.
the notch in the cooktop.
3. Wipe with warm soapy water. Use soapy
steel wool pad on stubborn spots.
DO NOT let the cookiop bump the upper oven when Illtlng.
DO NOT drop the tooktop. Damage can result.
13