Filter
Top Products
I
I I’
To
remove rack, pull
forward until rack
stops, lift front and pull.
Using the oven light
The oven light will come on when the oven door is opened.
To replace the oven light bulb:
The oven light bulb has a glass cover which is held on by a wire
holder. This cover must be in place when the oven is being used.
1. Turn off the electric power at the main power supply.
2 Pull out on the wire holder and move it to one side. This will let you
remove the glass cover.
Oven rack positions
Your oven has two racks. Always put the racks where you want
them to be before you turn on the oven.
To remove a rack, take hold of it on the front edge and pull it out
until it stops. Then lift up the front edge and pull again. It will slide past the
stops, out of the guides and out of the oven.
To put it back, fit the back corners into the guides at each side of
the oven and slide it in, keeping the front tilted up until the rack passes
the stops in the rack guides.
For:
Baking
Broiling
Roasting LARGE
cuts of meat
Roasting
SMALLER
cuts of meat
Place Rack:
On the second rackguide from the bottom or
so food is in the center of the oven.
So food is about the distance from the broil
element suggested in the broiling timetable
under “Using the Oven Controls.”
On the bottom rack guides.
So food is in the center of the oven.
When baking, always leave at least 1% to 2 inches (4-5 cm) of
air space between the sides of a pan and other pans and the oven wall
for air circulation.
For best results, get additional information on placing pans, cookie
sheets and other utensils from the “Cooking Guide.”
To replace the oven
light, remove glass
cover.
3. Replace the bulb with a 40-watt appliance bulb (designed to stand
up to oven heat) available at most grocery, variety and hardware
stores.
4. Replace glass cover. Snap the wire holder in place