Filter
Top Products
Install properly.. .
1. Allow W’ (.2 cm) space on each side and at top for
ease of installation.
2. If the refrigerator is to be in a corner, keep 1%
inches (3.1 cm] between the wall and the side of
the refrigerator so there is room to open the doors
wider.
3. The refrigerator back can be flush against the
wall.
Level refrigerator-freezer.. .
Rlght to Rake;
1ert to Lower
I. Remove base grille [see page 7 1.
2. To raise front, turn each screw to the right.
3. To lower front, turn each screw to the left.
4. Check with level.
Remove sales labels...
Remove the Consumer Buy Guide label, tape and
any
Inslde
labels before using the refrigerator
To remove any remalnlng glue:
1. Rub briskly with thumb to make a ball then remove
OR
2. Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water] before
removing glue as described in step 1.
DO NOT USE rubbing alcohol or ttammable or
toxic solvents, suoh as acetone, gasoline, car-
bon tetrachlorlde, etc. These can.damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIQERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the tront.
Clean it...
Clean your refrigerator before using it. See cle
ing instructions on page 8.
Plug it in...
j-prong
grounding type \
wall receptacle
I II
I
.
grounding plug
Retrigerator
Power Cord
Recommended
Grounding Method
A 115 Volt, 60 Hz.. AC only, 15 or 20 ampere fused
electrical supply is required. It is recommended that
a separate circuit serving only this appliance
be provided.
Do not use an extension cord. Use
a receptacle
whloh oafmot be turned off wtth a swttoh or pull
chain. See
individual electrical requirements and
grounding instruction sheet in your literature
package.