Filter
Top Products
Ice cube trays.. .
To remove Ice:
l
Hold tray at both ends.
l
Slightly twist.
If cubes are not used, they may shrink. The moving
cold air starts a slow evaporation. The longer cubes
are stored, the smaller they get.
Optional automatic ice maker.
On
8 Slgnal
to Stop Ice
lower Slgnal
Arm to Start It.
. .
1 Maker.
If you have the automatic ice maker accessory or
plan to add one later (Part No. ECKMF-oj), there are a
few things you will want to know:
l
The ON/OFF lever is a wire signal arm.
Down. .for making ice automatically;
Up...toshut off the ice maker.
l
Shake the bin occasionally to keep cubes sepa-
rated, and to obtain increased storage capacity.
l
It is ncxmal for ice crescents to be attached by a
corner. They will break apart easily.
l
You will hear water running when ice maker is
working. You’ll hear ice fall into the bin. Don’t let
these sounds bother You.
a The ice maker will not operate until the freezer is
cold enough to make ice. This can take overnight.
l
Because of new plumbing connections, the first
ice may be discolored or off-flavored. Discard the
frrst few batches of ice.
l
If ice is not being made fast enough and more ice
is needed, turn the Temperature control to a higher
number. Wait a day and, if necessary. turn the Air
Control to a higher number.
l
If you remove the ice bin, raise the signal arm to
shut off the ice maker. When you return the bin,
push it all the way in and lower the arm to the ON
position
l
If cubes are stored too long, they may develop an
off -flavor., like stale water. Throw them away. They
will be replaced. Cubes in the ice bin can also
become smaller by evaporation.
l
The ice maker water supply
should not be soft-
ened
water. The chemicals could damage the ice
maker molds.
Changing light bulbs...
WARNING: Beiore removing a light shield for
cleaning or for replaclng ihe bulb,
unplug the refrlgerutor or turn off lhe
electrlclty leadlng to the refrlg-
erator at the maln power supply.
Shock and InJury can occur If elec-
trlclty remains connected.
Pull Ott the Dial;
Pull Out at the Botto
Light bulbs behlnd refrigerator and freezer con-
trol consoles:
1, Pull control knob straight off.
2. Pull bottom of control panel straight out.
3. Lift top of panel off supports.
4. Replace with a 40-watt appliance bulb.
5. Replace panel in reverse order
Light bulb above crisper:
1. Pull top of the light shield away from the back wall
2. Lit? shield off base supports.
3. Replace with a 40-watt appliance bulb.
4. Replace shield in reverse order
Removing the base grille...
l
Open the doors
l
Pull grille outwards as shown,
l
Do not remove Tech sheet
fastened behind grille.
To replace:
l
Line up grille support tabs with metal clips.
l
Push firmly to snap into place.
l
Close the doors.