11
6. To remove freezer
handle: Reverse
handles while doors
are off. Remove the
two screws attaching
handle to the bottom
of the freezer door.
Swing bottom of
handle away from
door, and slide handle
straight up and off of
dovetail button.
Remove screw and
dovetail button, and install on other side, using the same
holes as the nameplate. To move nameplate to other side,
remove nameplate from its frame, turn frame upside down
and install in old handle holes. Insert nameplate into frame.
Reverse instructions for reattaching handle. Start with handle
offset away from door. Place top of handle over dovetail
button, swing handle into an upright position and push upward,
locking it into place. Secure bottom of handle with screws.
7. To remove
refrigerator handle:
Remove the two
screws attaching the
handle to the top of
the refrigerator door.
Swing the top of
handle away from the
door and slide handle
down and off of
dovetail button.
Remove screw and
dovetail button and
install on other side
moving hole plugs
from corresponding
holes to the opposite
side. Reverse
instructions for
reattaching handle.
Start with handle
offset away from the door. Place bottom of handle over
dovetail button, swing handle into an upright position and
push downward, locking it into place. Secure top of handle
with screws.
Trim Removal (Full-Length Trim models only)
In some models, the refrigerator door has a full length trim
piece which continues from the bottom of the handle to the
bottom of the door. The top of the trim fits into the base of
the handle. An adhesive "trim lock" is positioned about half-
way down. The bottom of the trim is held in place by either
an adhesive trim lock, or a trim lock with two prongs
inserted into a hole on the face of the door. Remove the
trim by gently pulling the trim lock areas out and away from
the door. When the trim is free from the door, gently pull
the trim down and away from the base of the handle.
Freezer Door
Refrigerator Door
To reattach trim: Slide both trim locks out of trim. Insert
the new adhesive trim locks contained in your literature
pack. NOTE: Trim lock must be removed and installed by
sliding OVER the two donut shaped areas. Install trim to
handle by sliding under base of handle. Carefully align trim
and press down at trim lock locations. Replace hole plug on
opposite side. Use rubbing alcohol to remove any adhesive
residue from old trim lock location(s).
8. Remove door
stop from bottom
of freezer and
refrigerator door
and reinstall on
opposite side.
9. If your
refrigerator does
not have a Toe
Grille, use a putty
knife to remove
the plastic plug
(not shown) from
front of base and
reinstall in the
opposite set of
lower hinge holes.
Assemble lower
hinge to cabinet.
Install hinge pin in
opposite hinge
hole from which it
was removed.
Install the washer
(some models) on
the lower hinge pin
and insert hinge
screws, but do not
tighten. Hinges will have to remain loose against cabinet to
align door.
or
10. Turn center
hinge upside down
and secure to
cabinet as shown,
using the screws
which are in the
new holes. Install
refrigerator door on
lower hinge pin.
Align door with
edge of cabinet.
Hold the door on
front of cabinet.
Refrigerator Door
Freezer Door