Filter
Top Products
10
WOLF COOKTOP VENTILATION HOODS
Secure the upper half of the support frame to
the joists and cross framing with four screws
p
rovided with your hood. Make sure that the
screws are driven into the center of the joists
and framing for maximum strength. Ensure the
c
orrect orientation of the support frame.
A
djust the overall height of the support frame.
Loosen and retighten the screws in the height
adjustment slots as necessary. Refer to the
illustration below.
IMPORTANT NOTE:
The hood height is 11
1
/4"
(286) from the support frame attachment point.
The bottom of the hood must be 24" (610)
minimum and 30" (762) maximum from the
countertop.
CONNECT DECORATIVE FLUE
Secure the upper telescopic chimney flue
section to the upper support frame. Refer to
the illustration below.
Temporarily hold the lower telescopic chimney
flue section over the upper flue section.
ISLAND HOOD INSTALLATION
ELECTRICAL REQUIREMENTS
T
he Wolf cooktop island hood requires a
separate, grounded 110/120 V AC, 60 Hz power
supply. The service should have its own 15
a
mp circuit breaker. Locate the electrical
supply with a minimum of 6' (1.8) of 120 V AC
power cable on the ceiling through the top of
the hood.
You must follow all National Electrical Code
regulations. In addition, be aware of local
codes and ordinances when installing your
service.
INSTALL SUPPORT SYSTEM
At the island hood installation location, install
two-by-four or
3
/4" (19) plywood cross framing
between ceiling joists. Refer to the island hood
mounting pattern dimensions below.
Finish the ceiling surface. Be sure to mark the
location of the ceiling joists and cross framing.
Determine the desired orientation of the island
hood. Note that the front designates the
control side of the hood.
TOP VIEW
FRONT OF HOOD
6
1
/2" (165)
10
7
/8" (276)
6
1
/2"
(165)
7
13
/16"
(198)
Front of
Support
Frame
Height
Adjustment
Slots
Wide
Mounting
Flange
Island hood mounting patterns Support frame orientation
Upper Flue
Lower Flue
Mounting Screws
Connect upper telescopic flue