Filter
Top Products
11
Dimensions in parentheses are in
millimeters unless otherwise specified.
INSTALLATION INSTRUCTIONS
ISLAND HOOD INSTALLATION
MOUNT HOOD TO SUPPORT FRAME
M
ount the hood to the support frame by
aligning the four weld screws on the hood to
the four holes on the support frame. Use four
n
uts to secure the hood to the support frame.
Refer to the illustration below.
Nest the bottom of the telescopic chimney flue
into the relief in the hood shell. Make electrical
connections.
ELECTRICAL CONNECTIONS
IMPORTANT NOTE:
This ventilation hood
must be properly grounded. This unit should
be installed by a qualified electrician in accord-
ance with all applicable national and local
electrical codes.
Remove the cover from the rear electrical box.
Remove the electrical box knockout that faces
the hood's discharge collar.
Insert 6" (152) of 120 V AC power cable through
the knockout opening. Secure the cable to the
electrical box with an appropriate connector.
Make electrical connections. Connect black to
black, white to white and green/yellow to
green or bare wire. Refer to the illustration
below.
Reinstall the electrical box cover and screws.
Make sure that all wires are secure and that no
w
ires are pinched between the cover and box.
R
efer to page 13 for internal blower installation
guidelines and remote blower wiring.
CONNECT DUCTWORK
Use an 8" (203) round metal duct to connect
the duct collar on the hood to the ductwork
above. Use duct tape to make all joints secure
and air tight.
Slide the lower telescopic chimney flue section
downward until it fits properly around the
hood shell.
Support
Frame
Decorative Flue
Nuts
Weld Screws on Hood
green/yellow to
green or
bare wire
black to
black
HOOD FRONT TOP OF HOOD SHELL
discharge
collar
120 V AC
power cable
rear
electrical
box
white
to white
Mount island hood to support frame Electrical connections
IMPORTANT
NOTE
You must follow
all National
Electrical Code
regulations. In
addition, be aware
of local codes and
ordinances when
installing your
service.