Filter
Top Products
7
INSTALLATION INSTRUCTIONS
WALL HOOD INSTALLATION
ELECTRICAL REQUIREMENTS
W
olf cooktop wall hoods require a separate,
grounded 110/120 V AC, 60 Hz power supply.
The service should have its own 15 amp circuit
b
reaker. Locate the electrical supply with a
minimum of 12" (305) of 120 V AC power
cable within the shaded area shown in the
illustration below.
You must follow all National Electrical Code
regulations. In addition, be aware of local
codes and ordinances when installing your
service.
INSTALL BACKSPLASH
If an optional backsplash is to be used, attach
it to the finished wall. Secure the hood
mounting brackets to the wall studs prior to
installing the backsplash. Refer to page 12 for
optional accessories.
INSTALL MOUNTING BRACKETS
C
onstruct wood wall framing that is flush with
the interior surface of the wall studs. Make
sure that the framing is centered in the hood
i
nstallation location, and that the height of the
framing will allow the mounting brackets to be
secured to the framing within the dimensions
shown in the illustration below.
After the wall surface is finished, secure the
mounting brackets to the framing using the
dimensions shown.
INSTALL THE HOOD
Hang the hood from the brackets through the
rectangular cut-outs on the back of the hood.
The cut-outs are larger than the brackets to
allow for vertical and horizontal adjustment.
Keep in mind that the bottom of the hood
should be 24" (610) to 30" (762) above the
countertop.
Use height adjustment screws to adjust the
hood vertically and the depth adjustment
screws to adjust the hood horizontally.
Secure the hood with additional mounting
screws. If wall studs or framing are not
available in the proper location, use the
drywall anchors provided with the hood
E
4" (102)
6"
(152)
30" OR 35
7
/16"
(762 or 900)
Framing Behind Drywall
Mounting Brackets
7
1
/2" (190)
(CTWH30)
9
3
/8" (238)
(CTWH36)
7
1
/2" (190)
(CTWH30)
9
3
/8" (238)
(CTWH36)
Electrical supply location Mounting bracket installation
Rectangular Cutouts
Mounting
Brackets
Wall Framing
Additional
Mounting Screws
Hood installation
ACCESSORIES
Optional acces-
sories are available
through your
Wolf dealer. To
obtain local dealer
information, visit
the Locator section
of our website,
wolfappliance.com.