Filter
Top Products
The hood assembly is shipped with the
rough-in plate/transition attached. The
transition is shipped upside down in the top
of the hood. It must be removed and rein-
stalled in the proper position.
Remove the filters by pushing each filter up
at the angle it is placed in, and rotate down.
Remove the center filter first. Then take out
the grease cups placed on the bottom edge
of the hood coinciding with the bottom edge
of the filters. Gloves should be worn to
provide the proper grip when removing
filters.
Detach the rough-in plate/transition
assembly from the hood by removing the
screws on the top and back of the assembly.
Separate the transition from the rough-in
plate by removing the four shipping screws.
Do not
discard the screws, they will be
needed to reinstall the transition to the
rough-in plate. Refer to the illustration
below.
Reattach the transition to the rough-in plate
using the four shipping screws removed
previously.
Attach the transition to existing ductwork
with sheet metal screws and duct sealing
tape.
14
WOLF PRO WALL VENTILATION HOODS
27" (686) DEEP WALL HOODS
STEP 2: WALL PREPARATION
Construct the wood wall framing flush with
the wall studs and centered in the location
that the hood will be mounted. Use the
rough-in plate shipped with hood to deter-
mine the location of the framing.
After the wall surface is finished, secure the
rough-in plate to the wall surface.
Framing must be tied together and to
ceiling joists to provide enough structural
strength to support the weight of the
hood and internal blower, if applicable.
If wall framing is not available, wall
anchors must be used.
*
*
*
*
*
*
*
*
*Dimension is 2" (51)
9
1
/2
" (241)
21
1
/4
" (540)
4
1
/2
" (114)
10" (254)
8
1
/2
" (216)
4
1
/2
"
(114)
4
1
/2
"
(114)
4
1
/2
" (114)
13
/16
" (21)
20" (508)
8" (203)
Mounting holes for 27" (686) hoods
Rough-In
Plate
Shipping
Screws
Transition
Rough-in plate installation
ACCESSORIES
Optional acces-
sories are available
through your
Wolf dealer. To
obtain local dealer
information, visit
the Locator section
of our website,
wolfappliance.com.
STEP 3: HOOD PREPARATION
IMPORTANT NOTE:
If a duct cover is to be
used, follow instructions on page 21 before
installing the wall hood.
Refer to the illustration below for the location
of mounting holes for the 27" (686) wall hood.