Filter
Top Products
6
E
4" (102)
15"
(381)
15"
(381)
2"*min (51)
CUT-OUTTO
COMBUSTIBLE
MATERIALS
(BOTH SIDES)
13
3
/8"(340)
COOKTOP CUT-OUT
WIDTH
13
3
/8"(
340)
COOKTOP CUT-OUT
WIDTH
33" (838)
RECOMMENDED
CABINET WIDTH
18"
(457)
NOTE: Application shown allows for installation of two 15" (381) modules side-by-side with 33" (838) recommended cabinet width.18" (457)
recommended cabinet width for installation of single 15" (381) cooktop or module. *Minimum clearance from both side edges of cooktop cut-out
to combustible materials up to 18" (457) above countertop. **Minimum clearance from rear edge of cooktop cut-out to combustible materials up
to 18" (457) above countertop.
19
1
/4" (489)
COOKTOP CUT-OUT
DEPTH
2
1
/2"min
(64)
36" (914)
STANDARD
FLOOR TO
COUNTERTOP
HEIGHT
13" max
(330)
30" (762)
COUNTERTOP TO
COMBUSTIBLE
MATERIALS
ABOVE COOKTOP
FRONT OF COUNTERTOP
2
1
/2"min
(64)
19
1
/4" (489)
COOKTOP
CUT-OUT DEPTH
2"**
(
51)
Overall Dimensions
Countertop Cut-Out
21"
(533)
OVERALL
DEPTH
15" (381)
OVERALL WIDTH
5" (127)3
3
/4" (96)
CONDUIT
MODEL CT15E
Overall Width 15" (381)
Overall Height 3
3
/4" (96)
Overall Depth 21" (533)
Minimum Cabinet Depth 22
3
/4" (578)
Minimum Height Clearance*
4" (102)
Cut-Out W
idth 13
3
/8" (340)
Cut-Out Depth 19
1
/4" (489)
INSTALLATION SPECIFICATIONS – MODEL CT15E
FRAMED
MODEL CT15E
The illustrations below provide installation
specifications for Model CT15E.
If Model CT15E is installed above cabinets, the
e
lectrical placement is not critical. A grounded
electrical box should be located within 4'
(1.2 m) of the right rear of the cooktop.
For installation above an oven, unless you are
using cabinets deeper than 24" (610), it is
recommended that the electrical supply be
placed in the base cabinet to the right of the
oven.
WOLF ELECTRIC COOKTOPS
IMPORTANT NOTE:
Do not block the cooling
fan located at the bottom of the cooktop.
*Minimum 5
3
/4" (146) clearance is required
between countertop and any combustible
surface directly below the cooktop.
For detailed conduit dimensions, refer to
the illustration on page 5.
Dimensions may vary to
±
1
/8" (3).