Filter
Top Products
Microwave Oven Care 43
wolfappliance.com
CONTROL PANEL
Care should be taken in cleaning the touch control panel.
If the control panel becomes soiled, open the door to
inactivate the oven controls before cleaning. Wipe the
panel with a cloth dampened slightly with water only. Dry
with a soft cloth. Do not scrub or use chemical cleaners.
Close door and touch STOP/CLEAR.
INTERIOR
Cleaning is easy because little heat is generated to the
interior surfaces; therefore, there is no baking and setting
of spills or spatters. To clean interior surfaces, wipe with a
soft cloth and warm water. Do not use abrasive or harsh
cleaners or scouring pads. For heavier soil, use baking
soda or a mild soap; rinse thoroughly with hot water.
Do not use chemical oven cleaners.
Cleaning and Care
The waveguide cover, located on the right interior wall
of the oven, is made from mica, so it requires special
care. Keep the waveguide cover clean to assure good
microwave performance. Carefully wipe with a soft
damp cloth any food spatters from the surface of the
cover immediately after they occur. Built-up spatters
may overheat and cause smoke or possibly catch fire.
Do not remove the waveguide cover.
Disconnect the power cord before cleaning or leave the
door open to inactivate the oven during cleaning.
EXTERIOR
Clean exterior surfaces of the microwave oven with mild
soap and water; rinse and dry with a soft cloth. Do not use
any type of household or abrasive cleaner.
Wipe the window on both sides with a soft damp cloth to
remove any spills or spatters. Metal parts will be easier to
maintain if wiped frequently with a soft damp cloth. Avoid
the use of spray and other harsh cleaners as they may
stain, streak or dull the door surface.
STAINLESS STEEL TRIM
The stainless steel trim should be wiped often with a soft
damp cloth and polished with a soft dry cloth to maintain
its beauty. There are also a variety of products designed
especially for cleaning and shining stainless steel. We
recommend that the cleaner be applied to a soft cloth and
then carefully wiped over the stainless steel trim, rather
than applied directly to it. Follow package directions.