Wolfgang Puck BFPR0007 Food Processor User Manual


 
20
Ensure that your food processor is unplugged from the electrical outlet
before cleaning.
Wipe the base and cord with a warm soapy cloth and wipe clean with a
damp cloth. Dry thoroughly. Do not use any abrasive cleaners or
scouring pads on the housing as this will damage the finish. Wash the
processing bowl, cover and all attachments (except motor base) in warm
water using a mild detergent (or see dishwasher instructions below).
Dry each part thoroughly before use.
Warning: Care must be taken when handling the metal blades as these
items are extremely sharp.
Dishwasher Use
All plastic components deteriorate through the prolonged use of a
dishwasher for cleaning. However all parts of your Food Processor are
tolerant to dishwasher use, (excluding the processor body). If using the
dishwasher place parts only on the top rack of your dishwasher.
Once your food processor and accessories have been cleaned and dried
thoroughly, store your food processor as outlined in the section “Storing
your Food Processor.”
Care and Cleaning
19
Disassembly of Your
Food Processor
.
figure 15
Warning: Always wait for the processing blade
to stop moving completely before removing the
cover. Blades are extremely sharp. Never
contact cutting surfaces of blades, always use
plastic center of blades and discs.
1 Remove the Processing Bowl cover by
turning counter-clockwise and lifting
straight up.
2 If using the Processing Blade, remove the
Spindle with Processing Blade attached.
Hold the Processing Blade by the plastic
center only. With your other hand, depress
the Processing Blade Locks inward while
lifting up on the plastic center of the
Processing Blade. See figure 16.
3 If using one of the Processing Discs, remove
first by grasping the center plastic section
of the Disc (see figure 17). Lift straight up to
remove, then remove center shaft.
4 To remove the Work Bowl, grasp the handle
and turn counter-clockwise to the 3 o’clock
position and lift straight up.
Only grasp under lip
figure 16
Push in Processing Blade
Locks on both sides of Spindle
figure 17
HSN_7CupFoodProcManual 4/20/09 10:51 AM Page 19