Filter
Top Products
16
1. Check the filters
Ensure they are clean and properly positioned
(see "Maintenance and cleaning").
2. Press the On/Off push button
The display will show the last selected
programme and the corresponding phase
indicator lights will illuminate.
If the door is open also the "open door" indicator
light will illuminate.
3. Check that there is rinse aid
and salt
The corresponding indicator lights will illuminate
if refilling is necessary.
4. Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the
saucepans, plates and cutlery in it.
Pull the upper basket out and arrange the
plates, saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
5. Ensure that the spray arms can
rotate freely.
6. Measure out detergent
Add the required amount of detergent into the
dispenser.
Close the detergent dispenser lid.
7. Close the dishwasher door
8a. Setting and starting the
programme without "delay
start"
Press the "programme selector" push button
until the required programme number
appears in the digital display.
The following options may also be
selected:
a- Half load by pressing the corresponding
push button.
b- Eco drying by pressing the corresponding
push button.
Press the START push button, an audible
signal advises you that the programme has
started.
The display will show the running time
of the programme and the indicator lights of
the phases will turn off except for the
indicator light of the current phase.
The time in the digital display will start to
decrease from minute to minute.
Pressing the "programme selector"
push button while the programme is running
will display the number of the current
programme.
If the door is opened during the run of the
programme the current phase will be
interrupted and the digital display will show
the number of the programme. The indicator
light of the interrupted phase will start to
flash and the indicator light "open door" will
illuminate.
Once the door is closed the programme will
start from the point where it was interrupted.
SEQ06en
Operating sequence