Filter
Top Products
17
8b. Setting and starting the
programme with "delay start"
Once a programme and required options
have been selected to use DELAY
proceed as follows:
Press the DELAY push button. The
digital display will show "h 0". Press the
button again to select the number of hours
by which you wish to delay the programme
start (up to a maximum of 12 hours).
The delay start will not modify the settings
made previously .
To set the time setting to zero press the
DELAY push button until "h 0" appears
in the digital display.
Press the START pushbutton.
The digital display shows the delay time
required before the start of the programme.
The start of the countdown will be confirmed
by the flashing "h" in the digital display.
Once the delayed time has elapsed the
programme will start automatically.
9. To cancel a programme in
progress
Press the "START" pushbutton for 5
seconds to cancel the setting or the running
of the current programme.
All the indicator lights will turn off and 3
horizontal lines will appear in the digital
display.
After 5 seconds the dishwasher will return to
setting mode.
It is now possible to select a new washing
programme.
10. At the end of the washing
programme
The dishwasher will automatically stop and
an intermittent audible signal will sound
when the programme has ended.
3 flashing horizontal lines will appear in the
digital display and all the indicator lights will
turn off.
To return to setting mode press any of the
pushbuttons or switch off and then switch on
the dishwasher.
Open the door and wait a few minutes
before removing the dishes; in this way
they will be cooler and the drying will be
improved.
Empty the lower basket first and then the
upper one; this will avoid water dripping
from the upper basket onto the dishes in
the lower one.
Important!
In general it is not advisable to open the
door while the machine is working; if the
door is opened however, a safety device
ensures that the machine stops.
Care must be taken if the door is opened
during the hot phase or immediately
after a programme has finished, as
steam may escape.
When the washing programme has
finished, it is recommended that the
dishwasher is unplugged and the water
tap turned off.
SEQ07en