Filter
Top Products
BUILDING-IN INSTRUCTIONS
Before carrying out any work, remove the plug from
the power socket.
Grid preparation
Remove the grid from the appliance pulling it towards
you by hand.
Right door opening:
Remove the left side (A) of the grid cutting it from the
rear (see figure, a).
Left door opening:
Remove the right side (B) of the grid cutting it from
the rear (see figure, b).
To reposition the grid on the appliance proceed as
follows:
Apply the grid to the base of the appliance by push-
ing the clasps (a) until they click.
N.B. The grid is to be assembled after having fixed
the appliance in the niche with the brackets.
13
S.I.001
a
a
Door reversal
The appliance must be unplugged before starting
work. To reverse the opening direction of the door,
proceed as follows:
1. remove the top hinge (1) taking care not to let the
door fall;
2. remove the bottom door hinge (2).
3. take out the plugs (3) from the holes (F) and rein-
sert them in the holes (F
1
) on the opposite side;
4. refit the upper hinge (1) on the opposite side, on
the bottom (position A);
5. refit the door on the pin of the hinge (1) in position
A;
6. insert the pin of the unscrewed bottom hinge (2) in
the upper hole (G) of the door, therefore fix the
hinge on the top in position B.
Attention
After completion of the door reversing opera-
tion, check that the door gasket adheres to the
cabinet. If the ambient temperature is cold (i.e.
in Winter), the gasket may not fit perfectly to
the cabinet. In that case, wait for the natural fit-
ting of the gasket or accelerate this process by
heating up the part involved with a normal
hairdryer on a low setting.
S.I.002
A
B
a
b
S.I.003
F
F
B
A
F
3
1
2
G
1
F
1
Building the appliance in under a
worktop
The dimensions of the recessed installation area
must correspond
with those indicat-
ed in the figure.
The appliance
could be inserted
between two units
(a) or as an end
unit (b).
S.I.004
600
550
600
600
820 - 870
b
a
min