Filter
Top Products
14
If the appliance is to be installed between two units
with a matching furniture door/support panel, the
door/panel must be fitted to the adjacent unit using
suitable hinges (not supplied) before the appliance is
installed.
S.I.006
30
3. The appliance is equipped with adjustable support
feet. To adapt the appliance to the height of the
installation area (max 870 mm), screw in, or screw
out the feet situated at each bottom corner.
4. Separate parts A, B, C, D as shown in the figure.
PR266
A
B
C
D
5. Place guide (A) on the inside part of the furniture
door, up and down as shown in the figure and
mark the position of external holes. After having
drilled holes, fix the guide with the screws sup-
plied.
20mm
A
50mm
PR166
D326
SUPER.
INFER.
UPPER LOWER
1. Fasten the side panel to the rear of the appliance
with the fixing brackets.
D319
E
E
SUPER.
INFER.
UPPER LOWER
2. Fasten the appliance to the worktop or the sides,
applying the sealing strip between the refrigerator
and adjacent cabinet using the fixing brackets (E).