Filter
Top Products
S.I.012
2
1
a
b
7
External cleaning
The appliance is equipped with an air inlet filter (1)
and an air outlet duct (2) on the ventilation grid. Keep
clean to guarantee good ventilation and good working
order of the appliance.
The filter can be removed and washed with water, as
follows:
1. Pinch flaps (a) and (b) with fingers
2. Pull the filter down.
3. Pull the filter out.
To replace the filter reverse the process.
An accumulation of dust will affect the performance of
the appliance and cause excessive electricity con-
sumption.
The structure of the appliance permits the cleaning of
the rear zone close to the wall, using a vacuum clean-
er.
1. Remove the plinth (1), then the ventilation grid (2);
2. Carefully pull the air deflector out (3), checking that
there is no water left from the defrosting process.
S.I.013
3
21
Warning
Before any maintenance or cleaning work is
carried out, DISCONNECT the appliance from
the ELECTRICITY supply.
This appliance contains hydrocarbons in its
cooling unit maintenance and recharging
must therefore only be carried out by autho-
rised technicians.
Internal cleaning
Clean the inside and accessories with warm water
and bicarbonate of soda (5ml to 0.5 litre of water).
Rinse and dry thoroughly.
NEVER USE DETERGENTS, ABRASIVE POW-
DERS, HIGHLY PERFUMED CLEANING PROD-
UCTS OR WAX POLISHES, TO CLEAN THE INTERI-
OR AS THESE WILL DAMAGE THE SURFACE AND
LEAVE A STRONG SMELL.
Important
Do not use abrasive products.
Clean the drain hole of the water trough at regular
intervals and make sure that the drain hole is never
obstructed, so that the defrost water may flow freely.
MAINTENANCE AND CLEANING