Filter
Top Products
PR33/2
C
A
6.Fix cover (C) on guide (A) until it clips into place.
8mm
PR167
A
B
7.Open the appliance door and the furniture door at
90°. Insert the small square (B) into guide (A). Put
together the appliance door and the furniture door
and mark the holes as indicated in the figure.
Remove the squares and drill holes with Ø 2 mm
at 8 mm from the outer edge of the door. Place the
small square on the guide again and fix it with the
screws supplied.
8.Should the lining up of the furniture door be neces-
sary, use the clearance of slots.
At the end of operations, it is necessary to check if
the door of the furniture closes properly.
PR168
PR167/1
D
B
9.Fix cover (D) on guide (B) until it clips into place.
Fitting the plinth
Important
For the efficient operation of the appliance, it is
important that the original ventilation grid is
used.
■ For an opening height dimension A=820 mm and
a plinth height dimension a=100 mm, the plinth
may be fitted without adjustments. The same
applies to an opening height dimension B=870
mm and a plinth height dimension b=150 mm.
■ For plinth heights greater than a=100 mm, b=150
mm, a cut should be made in the plinth, 580 mm
wide, in the centre of the appliance position, leav-
ing a remaining height of a=100 mm, b=150 mm.
■ Attach plinth to the kitchen units.
Important
The plinth must be positioned at a minimun
distance of 25 mm from the door.
S.I.007
S.I.008
580
a = 100
b = 150
25 - 80
A = 820
B = 870
25
15