Filter
Top Products
Installation - Internal B lower
9
6. Attach junction box to internal ange using
provided 1/2” self tapping screws and 4mm
internal diameter washers.
7. Attach grounding wires from junction box
and motor to grounding screw as shown.
8. Place blower with attached ange into
motor housing as shown on Fig-A.
9. Attach using 1/2” self tapping screws to
secure in place.
10. Att
ach other end of capacitor box
connector and junction box connector to
control board box and wiring box connector
inside hood.
Continue to page “11” for hood inst
allation instructions.
For external blower installation please refer to the manual
included with the external blower.