8-2
Cisco IE 3010 Switch Software Configuration Guide
OL-23145-01
Chapter 8 Configuring SDM Templates
Configuring the Switch SDM Template
Configuring the Switch SDM Template
These sections contain this configuration information:
• SDM Template Configuration Guidelines, page 8-2
• Setting the SDM Template, page 8-3
SDM Template Configuration Guidelines
Follow these guidelines when selecting and configuring SDM templates:
• When you select and configure SDM templates, you must reload the switch for the configuration to
take effect.
• If you try to configure IPv6 features without first selecting a dual IPv4 and IPv6 template, a warning
message is generated.
• Using the dual stack templates results in less TCAM capacity allowed for each resource, so do not
use if you plan to forward only IPv4 traffic.
IPv4 unicast routes: 0
IPv6 multicast groups 1.125 K
Directly connected IPv6 addresses 0
Indirect IPv6 unicast routes 0
IPv4 policy-based routing ACEs 0
IPv4 or MAC QoS ACEs 0.75 K
IPv4 or MAC security ACEs 1 K
IPv6 Policy-based routing access control
entries (ACEs)
0
IPv6 or MAC QoS ACEs 0.625 K
IPv6 security ACEs 0.5 K
Table 8-2 Approximate Feature Resources Allowed by a Dual IPv4-IPv6 Template (continued)
Resource Default
