12-11
Cisco IE 3010 Switch Software Configuration Guide
OL-23145-01
Chapter 12 Configuring Interface Characteristics
Using Interface Configuration Mode
Beginning in privileged EXEC mode, follow these steps to configure a range of interfaces with the
same
parameters:
When using the interface range global configuration command, note these guidelines:
• Valid entries for port-range, depending on port types on the switch:
–
vlan vlan-ID - vlan-ID, where the VLAN ID is 1 to 4094
–
, where the module is always 0
–
fastethernet module/{first port} - {last port}, where the module is always 0
–
gigabitethernet module/{first port} - {last port}, where the module is always 0
–
port-channel port-channel-number - port-channel-number, where the port-channel-number
is
1 to 24
Note When you use the interface range command with port channels, the first and last
port-channel number must be active port channels.
• You must add a space between the first interface number and the hyphen when using the
interface
range command.
For example, interface range gigabitethernet 0/1 - 4 is a valid range; interface range
gigabitethernet0/1-4 is not.
• The interface range command only works with VLAN interfaces that have been configured with
the interface vlan command. The show running-config privileged EXEC command displays the
configured VLAN interfaces. VLAN interfaces not displayed by the show running-config
command cannot be used with the interface range command.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
interface range {port-range | macro
macro_name}
Specify the range of interfaces (VLANs or physical ports) to be
configured, and enter interface-range configuration mode.
• You can use the interface range command to configure up to five
port ranges or a previously defined macro.
• The macro variable is explained in the “Configuring and Using
Interface Range Macros” section on page 12-12.
• In a comma-separated port-range, you must enter the interface
type for each entry and enter spaces before and after the comma.
• In a hyphen-separated port-range, you do not need to re-enter the
interface type, but you must enter a space before the hyphen.
Step 3
Use the normal configuration commands to apply the configuration
parameters to all interfaces in the range. Each command is executed
as it is entered.
Step 4
end Return to privileged EXEC mode.
Step 5
show interfaces [interface-id] Verify the configuration of the interfaces in the range.
Step 6
copy running-config startup-config (Optional) Save your entries in the configuration file.
