Front Panel Operation
5-18
Assigning a Name to a Logical Drive
Press ENT for two seconds to enter the
Main Menu. Press ▼ or ▲ to select
"View and Edit Logical Drives..," then
press ENT.
Press ▼ or ▲ to select a logical drive,
then press ENT.
Press ▼ or ▲ to select “Logical Drive
Name," then press ENT.
Press ▼ or ▲ to change the character of
the flashing cursor. Press ENT to
move the cursor to the next space. The
maximum number of characters for a
logical drive name is 25.
Rebuilding a Logical Drive
If you want the controller to auto-detect a replacement drive, make
sure you have the following items set to enabled:
1. Periodic Drive Check Time
2. Periodic Auto-Detect Failure Drive Swap Check Time
These two configuration options can be found under “View and Edit
Configuration Parameters” -> “ Drive-Side SCSI Parameters”.
Press ENT for two seconds to enter the
Main Menu. Press ▼ or ▲ to select
"View and Edit Logical Drives..", then
press ENT.
Press ▼ or ▲ to select the logical drive
that has a failed member, then press
ENT.
Press ▼ or ▲ to select “Rebuild Logical
Drive," then press ENT.
Press ENT for two seconds to start
rebuilding the logical drive.
The rebuilding progress will be
displayed (as a percentage) on the
LCD.
Enter LD Name:
_
Rebuild Logical
Drive ?
Rebuilding 25%
Please Wait!
View and Edit
Logical Drives ↕
View and Edit
Logical Drives ↕
LG0 RAID5 DRV=3
2012MB GD SB=1
LG0 RAID5 DRV=3
2012MB FL SB=0
Logical Drive
Name ..
Rebuild Logical
Drive ..
