Extron Electronics MLC 104 Plus Series Manual

A SERVICE OF

next previous

i

MLC 104 Plus Series • Table of Contents

i

Table of Contents

Chapter One • Introduction ....................................................1-1

About this Manual .................................................................... 1-2

The MLC 104 Plus Series MediaLink

™

Controllers ........... 1-2

Differences between models ................................................ 1-2

About Global Congurator ....................................................1-4

System Requirements ............................................................1-5

Installing Global Congurator .............................................. 1-5

Global Congurator Online Training .................................. 1-6

Chapter Two • Hardware Setup............................................2-1

Front Panel ................................................................................... 2-2

Right Side Panel .........................................................................2-3

Left Side Panel and Top Panel ...............................................2-4

Power Connection ..................................................................... 2-5

LAN Connection (IP Models Only ........................................ 2-6

Front Panel Host Conguration Port ...................................2-7

Device Connections ................................................................... 2-8

Display connection ................................................................. 2-8

Infrared (IR connection ......................................................... 2-8

Digital I/O connection ............................................................ 2-8

Comm Link connection .......................................................... 2-9

MLS connection ...................................................................... 2-9

Chapter Three • Software Setup ......................................... 3-1

Creating a Global Congurator Project File ...................... 3-2

Step one: download device drivers ...................................... 3-2

Step two: create a new project ............................................. 3-4

For IP models ..........................................................................3-4

For an MLC 104 Plus (non-IP model......................................3-5

Step three: add a device and set up its connection ............ 3-6

For IP models ..........................................................................3-6

For an MLC 104 Plus (non-IP model......................................3-8

Step four: dene the location of the new device

(IP models only...................................................................... 3-9

Step ve: save the new Global Congurator le .............. 3-10

Conguring a New Device .................................................... 3-11

Step six: congure e-mail server (IP models only ............ 3-11

Step seven: congure e-mail messages (IP models only . 3-12

Step eight: congure contacts (IP models only ................3-13

Table of Contents