Control panel message Description Recommended action
REPLACE FUSER KIT
For help press
The fuser kit is at end of life. 1.
Press
for help.
2. Follow the instructions on the display
to locate and install the fuser kit.
3. Answer Yes to the question, Is this
a new fuser kit?
4. Press
and to step through the
instructions.
5.
To exit help, press
.
Supplies ordering information is also
available from the embedded Web
server. See
Using the embedded Web
server for more information.
REPLACE SUPPLIES
For status press
At least one supply item is out and needs
to be replaced and another supply item is
either out or low.
1. Press to identify which supplies
should be replaced.
2.
Press
for help.
3. Follow the instructions on the display
to locate and replace the identified
supply.
4. Press
and to step through the
instructions.
5.
To exit help, press
.
Supplies ordering information is also
available from the embedded Web
server. See
Using the embedded Web
server for more information.
REPLACE TRANSFER KIT
For help press
The transfer unit is at end of life. 1.
Press
for help.
2. Follow the instructions on the display
to locate and install the transfer kit.
3. Answer Yes to the question, Is this
a new transfer kit?
4. Press
and to step through the
instructions.
5.
To exit help, press
.
Supplies ordering information is also
available from the embedded Web
server. See
Using the embedded Web
server for more information.
Request accepted
Please wait
The printer has accepted a request to
print an internal page, but the current job
must finish printing before the internal
page will print.
No action necessary.
Resend
upgrade
The firmware upgrade was not completed
successfully.
Attempt upgrade again. You may need to
use the parallel port to send the upgrade
file.
128 Chapter 8 Problemsolving ENWW
