14
NS-51P680A12/NS-59P680A12
www.insigniaproducts.com
Connecting an antenna or cable TV (no box)
To connect an antenna or cable TV (no box):
1 Turn off your TV and all connected equipment.
2 Connect a coaxial cable between the ANT IN
jack on the back of your TV and the antenna or
cable TV wall jack.
3 Turn on your TV.
4 Go through the setup wizard on page 20.
Connecting a DVD or Blu-ray player
Using HDMI (best)
To connect a DVD or Blu-ray player using HDMI:
1 Turn off your TV and all connected equipment.
2 Connect an HDMI cable (not included) between
the HDMI IN 1(DVI) or HDMI IN 2 jack on the
back of your TV and the HDMI OUT jack on the
DVD or Blu-ray player.
3 Turn on your TV, then turn on the DVD or Blu-ray
player.
4 Press INPUT one or more times to select
HDMI 1/DVI or HDMI 2.
Notes
• If the signal level for a channel is weak, the
picture may be distorted. Adjust the antenna or
use a highly directional outdoor or set-top
antenna with a built-in amplifier.
• If the picture quality is good on some channels
and poor on others, the problem may be caused
by a poor or weak signal from the broadcaster
or cable TV provider.
• If you connect to cable or satellite TV without a
set-top box and experience poor picture quality,
you may need to install a set-top box to improve
signal reception and picture quality. Contact
your cable or satellite TV provider about
upgrading to a set-top box.
• Many high-definition (HD) channels upscale
standard-definition (SD) content. The picture
displayed on your TV is still displayed as SD, thus
the picture quality will not be as clear or crisp as
it would be if the content was originally
recorded in HD.
Back of TV
Coaxial cable
Outside antenna or cable TV
wall jack (no box)
Back of TV
DVD or Blu-ray player
HDMI cable
