Finalizing the Installation (for qualified installers only) 19
Travis Industries 100-01142 4050114
Glass Removal
WARNING : Make sure the gas control valve is “OFF” and the heater is cool prior to conducting service.
Lift the stove top off the
stove and place
it aside.
a
Twist 1/4 turn.
The spring pin will
disengage from the
latch bracket,
opening the latch.
Latch Bracket
Insert the 1/4” key
into the spring
pin.
Glass
Top of
Firebox
Spring Pin
Re-Attaching the Glass Frame:
a) Slide the two brackets on the bottom of the glass frame into the
glass frame guides (hold the glass frame at a slight angle.
b) Swing the glass frame into place - you may have to lift it slightly
to allow it to fit over the top of the firebox.
c) Attach the upper latches (follow the instructions above in reverse).
d) Replace the stove front, doors, and top.
Open the two latches holding the glass frame in
place - follow the directions shown below
Lift the face of the stove up, swing
the bottom out, and slide it down.
Place it aside.
d
Lift the glass frame slightly, swing the top forward, then lift
the glass frame to disengage it from the bottom guides.
Glass Frame Guide
Glass Frame
b
Swing the
doors open,
lift them off
the hinges,
and place
them aside.
NOTE:
If the face does not slide away,
loosen the screws holding these
tabs in place.
c
