Lopi Direct Vent Freestanding Stove Manual

A SERVICE OF

next previous

34 Optional Equipment (for qualified installers only)

Travis Industries 100-01142 4050114

3 Follow the directions below to remove the natural gas orifice. Apply thread sealant to the LP orifice ( it

has "1.2" stamped on it) and tighten in place with a 1/2" open end wrench.

a

Slide the air shutter all

the way to the left.

Burner Orifice

Manifold

1/2" Wrench

Use a 1/2” open end wrench to

unscrew the burner orifice.

NOTE:

Screw the LP orifice in

so the orifice shoulder

protrudes 5/16”

(indicating full insertion).

48

1.2

The new LP orifice

has “1.2” stamped

on it.

The old NG

orifice has “48”

stamped on it.

Apply thread

sealant to the

new orifice and

install.

5/16”

d

e

4 Remove the pilot orifice following the instructions below. Replace with the propane pilot orifice. The

propane conversion kit includes pilot orifice with "35" stamped on it. Replace burner pan.

Lift the pilot hood

off the pilot

assembly.

5/32" Hex

Use a hex wrench to

unscrew the orifice.

Remove the orifice and replace with the LP orifice. Screw the

orifice all the way in and replace the pilot hood.

LP (Propane) Orifice

Orifice Identification:

NG (Natural Gas) Orifice

35

62

35

a

b

c

NOTE: when re-attaching,

this pin lines up with the

notch in the pilot hood.