Finalizing the Installation (for qualified installers only) 21
Travis Industries 100-01142 4050114
Log Installation
! Make sure the gas control valve is “OFF” and the heater is cool prior to conducting service.
! Failure to position the parts in accordance with these diagrams or failure to use only parts specifically
approved with this appliance may result in property damage or personal injury.
Place the rear log so it rests
against the ledge on the
back wall of the firebox.
Push on the outer edges to
insure it sits up straight.
Note how it does not cover
any of the burner holes.
Place the twig so the pin on the rear
log inserts into the hole on the twig.
NOTE: you may need to tilt the rear
log forward to insert the pin.
Place the embers
over the front and
side edges of the
burner in a random
pattern (do not place
them over the burner
holes).
Installing the Rock Wool:
The rock wool comes in one
clump. Tear off “dime” sized
clumps and flatten. Then pull on
the wool to create gauze-like
pieces. Place them near some of
the burner holes. The wool
glows best when very thin and
porous.
Front View of Logs
Align the edge of the
log with the edge of
the burner.
NOTE: Rotate the front log so there
is a 1/8” to 1/4” gap along the front
of the log
1/8” - 1/4”
