Tie Lines
Aspire Software Manual Features ◆ 563
Programming
➻
10-09-01 : DTMF and Dial Tone Circuit Setup
If the system has DTMF tie lines, be sure to reserve at least one circuit for analog trunk
DTMF reception (type 0 or 2).
● Use the following as a guide when allocating DTMF receivers:
- In light traffic sites, allocate one DTMF receiver for every 10 devices that use them.
- In heavy traffic sites, allocate one DTMF receiver for every five devices that use them.
➻ 14-01-02 : Basic Trunk Data Setup - Transmit CODEC Gain Type
14-01-03 : Basic Trunk Data Setup - Receive CODEC Gain Type
Customize the transmit and receive levels of the CODEC Gain Types for each trunk as
required.
➻ 14-01-13 : Basic Trunk Data Setup - Loop Disconnect Supervision
Enable (1) loop supervision for each tie line that should be able to place outgoing calls.
➻ 14-02-01 : Analog Trunk Data Setup - Signaling Type (DP/DTMF)
Set the outgoing signaling type for the tie trunk. The options are 0 (DP 10 pps), 1 (DP 20 pps)
and 2 (DTMF). To set incoming signaling, refer to Program 34-01-02.
➻ 14-05-01 : Trunk Groups
Program tie lines of similar type into the same trunk group. The system uses trunk groups for
outgoing access to tie lines (i.e., Service Code 804 + group). Also see Program 34-05.
➪ Aspire Trunk Groups: 1-100
➻ 14-06-01 : Trunk Group Routing
When a tie line user dials 9, the system uses the routes defined in this program. Also see Pro-
gram 34-03. (If the system has ARS, the tie line user accesses ARS when they dial 9.)
➪ Aspire Trunk Group Routes: 1-100
➻ 20-01-05 : System Options - DTMF Receiver Active Time
After answering the tie line call, the system attaches a DTMF receiver to the tie line for this
interval (0- 64800 seconds).
➻ 20-06-01 : Class of Service for Extensions
Assign a Class Of Service (1-15) to extensions.
➻ 20-09-01 : Class of Service Options (Incoming Call Service) - Second Call for DID/
DISA/ DIL/ E&M
Enable (1) or disable (0) an extension’s ability to receive a second call from a DID, DISA,
DIL, or tie line caller.
➻ 20-14-01 : Class of Service Options for DISA/E&M
Enable (1) or disable (0) the following options for each tie line Class of Service (1-15):
● First Digit Absorption (Item 1)
● Trunk Group Routing/ARS Access (Item 2)
● Trunk Group Access (Item 3)
● Common Abbreviated Dialing (Item 4)
● Operator Calling (Item 5)
● Internal Paging (Item 6)
● External Paging (Item 7)
● Direct Trunk Access (Item 8)
● Forced Trunk Disconnect (Item 9)
● Call Forward Setting by Remote Via DISA (Item 10)
● DISA/Tie Trunk Barge In (Item 11)
