1
P/N: 4809650
©2004 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
11NOV04 v1.0 03DodgeHemi(4809650v1.0)
Section 4
HEATER HOSE RELOCATION
A. Install a supplied 3/8" x 45° street elbow
into the front cover of the engine, install the
second supplied 3/8" x 45° street elbow into
the previously installed elbow. Install the
factory hose barb fitting that was removed
in Step 1-e and install into the open end of
the street elbow.
*** NOTE ***
Assemble the fittings using Teflon paste to aid in
sealing. Attach the “J” shaped hose to the hose barb
and secure with a supplied hose clamp. Orientate
the fittings and hose as seen in Fig 4-a.
*** NOTE ***
These fittings may need to be re-oriented to clear
the supercharger support bracket.
4. HEATER HOSE RELOCATION
Fig. 4-a
B. Install the supplied 5/8" hose mender into
the open end of the “J” shaped hose and
secure with a supplied hose clamp.
C. Trim the factory coolant hose for best fit-
ment and connect to the open end of the
supplied 5/8" hose mender. Secure using a
supplied hose clamp.
4. HEATER HOSE RELOCATION
