2
P/N: 4809650
©2004 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
11NOV04 v1.0 03DodgeHemi(4809650v1.0)
I. Locate the air intake temperature sensor pre-
viously removed, install into the unthreaded
bung on the 180° inlet elbow. Locate the air
temperature sensor factory plug, strip back
the tape to expose the wires and cut the
wires approximately 3" from the connector
plug. Using the supplied 12" length of wires
extend the connector plug to reach the relo-
cated air temperature sensor.
*** NOTE ***
It is recommended that these wire connections be
soldered and heat shrink used to insulate the con-
nections to ensure the best contact.
J. Cut 2" off the short end of a supplied 3/4"
90° elbow hose. Attach the cut end onto the
oil fill neck breather barb. Install a supplied
3/4" hose mender into the open end of the
installed elbow hose.
K. Cut a 13" long section of the supplied
straight 3/4" hose and connect one end onto
the hose mender previously installed, con-
nect the opposite end onto the 3/4" 90° hose
barb previously installed into the supplied
180° air inlet duct.
L. Tighten all hose clamps.
Fig. 7-c
