P/N: 4809650
©2004 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
11NOV04 v1.0 03DodgeHemi(4809650v1.0)
iv
B
efore beginning this installation, please read
through this entire instruction booklet and
the Street Supercharger System Owner's
Manual which includes the Automotive Limited
Warranties Program and the Warranty Registration
form.
Paxton supercharger systems are performance
improving devices. In most cases, increases in
torque of 30-35% and horsepower of 35-45% can
be expected with the boost levels specified by
Paxton Automotive. This product is intended for
use on healthy, well maintained engines.
Installation on a worn-out or damaged engine is
not recommended and may result in failure of the
engine as well as the supercharger. Paxton
Automotive is not responsible for engine damage.
Installation on new vehicles will not harm or
adversely affect the break-in period so long as fac-
tory break-in procedures are followed.
For best performance and continued durability,
please take note of the following key points:
1. Use only premium grade fuel 91 octane or
higher (R+M/2).
2. The engine must have stock compression
ratio.
3. If the engine has been modified in any way,
check with Paxton prior to using this prod-
uct.
4. Always listen for any sign of detonation
(pinging) and discontinue hard use (no
boost) until problem is resolved.
5. Perform an oil and filter change upon com-
pletion of this installation and prior to test
driving your vehicle. Thereafter, always use a
high grade SF rated engine oil or a high
quality synthetic, and change the oil and fil-
ter every 3,000 miles or less. Never attempt
to extend the oil change interval beyond
3,000 miles, regardless of oil manufacturer's
claims as potential damage to the super-
charger may result.
6. Before beginning installation, replace all
spark plugs that are older than 1 year or
10,000 miles with original heat range plugs
as specified by the manufacturer and reset
timing to factory specifications (follow the
procedures indicated within the factory
repair manual and/or as indicated on the
factory underhood emissions tag). Do not
use platinum spark plugs unless they are
original equipment. Change spark plugs at
least every 15,000 miles and spark plug
wires at least every 50,000 miles.
RECOMMENDED TOOLS
FOR INSTALLATION:
1. Factory Repair Manual
2. 3/8" Socket and Drive Set: SAE & Metric
3. 1/2" Socket and Drive Set: SAE & Metric
4. 3/8" NPT Tap and Handle
5. Adjustable Wrench
6. Open End Wrenches: Metric and Standard
7. Center Punch and a 5/8" Tapered Punch
8. Springlock 3/8" and 5/8”Fuel Fitting
Disconnect Tool
9. 5 Quarts SH/CF Rated Quality Engine Oil
10. Oil Filter and Wrench
11. Flat #2 Screwdriver
12. Phillips #2 Screwdriver
13. Heavy Grease
14. Silicone Sealer
15. Drill Motor
16. 1/8", 3/16", 27/64" Drill Bits
17. Wire Strippers and Crimpers
18. Utility Knife
19. Power Steering Pulley/Puller & Installer
20. Pliers
If your vehicle has in excess of 10,000 miles
since its last spark plug change, then you will
also need:
21. Spark Plug Socket
22. NEW Spark Plugs
2002 Dodge Hemi
RECOMMENDED TOOLS FOR INSTALLATION
