1
P/N: 4809650
©2004 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
11NOV04 v1.0 03DodgeHemi(4809650v1.0)
Section 6
SUPERCHARGER MOUNTING BRACKET
6. SUPERCHARGER MOUNTING BRACKET
A. Locate the supplied two small supercharger
mounting plate support brackets bolts and
washers. Assemble the two brackets using
the four 5/16" x 18 x 1.0" bolts and washers
that are provided.
B. Using the supplied support bracket and the
supplied 8mm x 120 bolts and 10mm x 130
bolts confirm that the heater hose fittings
and hose previously installed clear the sup-
port bracket.
C. Remove the 15mm headed bolt closest to the
passenger side on the alternator that secures
the alternator to the front cover. (See Fig.
6-a.) This bolt will be reused to secure the
alternator in a later step.
Fig. 6-a
15mm ALTERNATOR BELT
D. Remove and set aside the factory plate that
secures the alternator, A/C compressor, and
front cover together. (See Fig. 6-b.)
Fig. 6-b
E. Loosen the remaining alternator retaining
bolt and rotate the alternator up leaving it
attached to the front cover. (See Fig. 6-c.)
Fig. 6-c
F. Remove the 13mm headed bolt just to the
left of the upper Idler pulley. Set it aside as
it will be reused in a later step. (See Fig.
6-d.)
Fig. 6-d
13mm HEADED BOLT
6. SUPERCHARGER MOUNTING BRACKET
