A SERVICE OF

logo

4-28 Service Manual
3. Connect the fuser to LVPS AC cable to the fuser lamp connector (F) at the LVPS.
Note: Be sure to connect the fuser to system board DC cable after replacing the LVPS.
Fuser exit sensor removal
1. Remove the fuser. See “Fuser assembly removal” on page 4-26.
2. Disconnect the fuser exit cable (A) from the fuser control board.
3. Remove the screw (B) securing the cover containing the fuser exit sensor, flag, and spring.
4. Release the two clips (C) holding the sensor in the bracket.
5. Unplug the fuser exit sensor cable from the sensor.