A SERVICE OF

logo

Open as PDF
next previous
4.26 Finger print sensor board 4 Replacement Procedures
TECRA M5 Maintenance Manual (960-542) [CONFIDENTIAL] 4-69
Installing the Finger print sensor board
To install the finger print sensor board, follow the steps below and refer to Figure 4-48.
1. Connect the finger print sensor cable to the connector on the finger print sensor
board.
2. Place the finger print sensor board in place while inserting the connecter side into
the guide.
3. Place the bracket while sliding it into the guide.
4. Stick the glass tape on the finger print sensor cable.
5. Pass the speaker cable through the guides.