Filter
Top Products
13
2011 June
700a-NA
4-SPECIFICATIONS (continued)
Specifications
6. Tape Roll Diameter
Up to 405mm [16 inch] maximum on a 76mm [3 inch] diameter core.
(Accommodates all system roll lengths of Scotch
®
fi lm tapes.)
7. Tape Application Leg Length – Standard
70 mm ± 6mm [2.75 inch ±. 25 inch ]
Tape Application Leg Length – Optional
50 mm ± 6mm [2 inch ±. 25 inch]
(See "Removing Taping Heads Procedure – Changing the Tape Leg Length")
8. Box Board
Style – regular slotted containers – RSC
125 to 275 P.S.I. bursting test, single wall or double wall B or C fl ute.
23-44 lbs. per inch of width Edge Crush Test (ECT)
9. Box Weight and Size Capacities
A. Box Weight, fi lled: 5 lbs.–65 lbs. [2.3 kg–29.5 kg]. Contents must support fl aps.
B. Box Size: Minimum Maximum
Length – 150mm [6.0 inch] Unlimited
Width – 150mm [6.0 inch]* 550mm [21.5 inch]
Height – 120mm [4.75 inch]** *** 620mm [24.5 inch] ***
* Cartons narrower than 250 mm [10 inch] in width may require more frequent belt replacement because
of limited contact area.
** 90 mm [3.5 inch] height with heads adjusted to apply 50 mm [2 inch] tape leg lengths.
(See "Special Set-Up Procedure – Changing the Tape Leg Length")
*** 165 mm [6.5 inch] minimum to 725 mm [28.5 inch] maximum height with columns adjusted to
upper position. (See "Special Set-Up Procedure – Box and Machine Bed Height Range",
Note: The case sealer can accommodate most boxes within the size range listed above. However, if the box
length (in direction of seal) to box height ratio is 0.6 or less, test run several boxes to ensure proper
machine performance.
DETERMINE THE BOX LIMITATIONS BY COMPLETING THIS FORMULA:
BOX LENGTH IN DIRECTION OF SEAL = SHOULD BE GREATER THAN 0.6
BOX HEIGHT
Any box ratio approaching this limitation should be test run to ensure performance.