Filter
Top Products
29
2011 June
700a-NA
13.1 Safety Measures (see section 3)
Carrying out maintenance and repairs may imply
the necessity to work in dangerous situations.
13.2 Tools and Spare Parts Supplied with
the Machine
See Spare Parts Order Section.
13.3 Recommended Frequency of Inspection and Maintenance Operations
Operation Frequency Qualification Sections
Inspection safety features daily 1 13.4
Cleaning of machine weekly 1 13.5
Cleaning of cutter blade weekly 2 13.6
Oiling of felt pad weekly 2 13.7
Lubrication monthly 2 13.7-13.8
Blade replacement when worn 2 See Manual 2
Drive belt replacement when worn 2 13.10
13.4 Inspections to be Performed Before and
After Every Maintenance Operation
Before every maintenance operation, Push the main
switch OFF (O) and disconnect. During the mainte-
nance operation, only properly trained and qualifi ed
personnel must work on the machine. At the end
of every maintenance operation check the safety
devices.
13-MAINTENANCE AND REPAIRS
13.5 Check Efficiency of Safety Features
1. Blade guard assembly upper taping head
2. Blade guard assembly lower taping head
3. Latching Emergency stop button with mechanical
lock (interrupt supply of electrical power)
4. Push the main switch STOP/OFF (O)
5. Safety guards top drive belts
13.6 Cleaning of Machine
Qualification 1
A weekly cleaning with dry rags or diluted detergents
is necessary. Cardboard boxes produce a signifi cant
quantity of dust and paper chips when processed
or handled in case sealing equipment. If this dust is
allowed to build up on machine components, it can
cause component wear and over-heating of drive
motors. The dust build up is best removed from the
machine with a vacuum cleaner. Depending on the
number of cartons processed, this cleaning should
be done weekly. Excessive build-up that cannot be
removed by vacuuming should be removed with a
damp cloth.
• To reduce the risk associated with
mechanical and electrical hazards:
− Read, understand, and follow all safety and
operating instructions before operating or
servicing the case sealer.
− Allow only properly trained and qualifi ed
personnel to operate and service this
equipment.
• To reduce the risk associated with
pinches, entanglement and hazardous
voltage:
− Turn electrical supply off and disconnect
before performing any adjustments,
maintenance or servicing the machine or
taping heads.
WARNING
13.7 Cleaning of Cutter Blade
Qualification 2
Should tape adhesive build-up occur, carefully wipe
clean with oily cloth or brush
(Figure 13-1). Oil pre-
vents the build-up of tape adhesive.
(See manual 2.)