3M 40800 Food Saver User Manual


 
17
2011 June
700a-NA
Figure 7-2
7-INSTALLATION
Figure 7-1
7.4 Machine Set-Up / Bed Height
Adjust machine bed height. The case sealer is
equipped with four (4) adjustable legs that are
located at the corners of the machine frame.
The legs can be adjusted to obtain different
machine bed heights (See Speci cations).
Refer to Figure 7-3 and set the machine bed height
as follows:
1. Raise and block up the machine frame to allow
adequate leg adjustment.
2. Loosen, but do not remove, two (2) M8 x 16
socket head screws in one leg (use M6 hex
wrench). Adjust the leg length for the desired
machine bed height. Retighten the two screws
to secure the leg. Adjust all four (4) legs equally.
Figure 7-3
M8 x 1.25mm
Socket Head
Screws
Adjustable
Leg
A tool kit containing some tools are supplied
with the machine. These tools should be
adequate to set-up the machine, however,
other tools supplied by the customer will be
required for machine maintenance.
7.3 Tool Kit Supplied with the Machine
7.1 Operating Conditions
The machine should operate in a dry and relatively
clean environment (See Speci cations).
7.2 Space Requirements for Machine Operation
and Maintenance Work
Minimum distance from wall (Figure 7-1):
A = 1000mm.
B = 700mm.
Minimum height = 2700mm.
To reduce the risk associated with
mechanical and electrical hazards:
Allow only properly trained and
quali ed personnel to operate and service
this equipment.
WARNING
To reduce the risk associated with
muscle strain:
Use the appropriate rigging and
material handling equipment when
lifting or repositioning this equipment.
Use proper body mechanics when
removing or installing taping heads
that are moderately heavy or may be
considered awkward to lift.
WARNING