Filter
Top Products
34
CARE AND CLEANING
Before cleaning always allow the cooling fan
to cool the appliance down before switching
off at the electricity supply.
CLEANING MATERIALS
Before using any cleaning materials on your
appliance, check that they are suitable and that their
use is recommended by the manufacturer.
Cleaners that contain bleach should NOT be used as
they may dull the surface finishes. Harsh abrasives
and scourers should also be avoided as damage will
occur.
CLEANING THE OUTSIDE OF THE
APPLIANCE
Do not use abrasive cleaning materials e.g. Hob
Brite, Brillo pads or scourers on painted or printed
finishes as damage may occur.
Regularly wipe over the control panel, doors and
handles using a soft cloth and hot soapy water. To
prevent streaking finish with a soft cloth.
Stainless Steel cream cleaners are abrasive and
should be avoided as they may dull the surface
finish. Any spillage on the stainless steel finish
must be wiped off immediately.
Do not attempt to remove any of the control
knobs from the panel as this may cause
damage and is a safety hazard.
REMOVING AND REPLACING THE
WIREWORK RUNNERS
1. Remove all shelves and furniture from the oven.
2. Hold the wirework at the bottom, unclip from the
cavity side and gently pull towards the centre of
the oven.
3. Unhook the runner at the top and remove from
the cavity.
4. To replace the runners, hook the wirework side
runner into the cavity, slide back and press into
place.
Ensure the wirework runners are firmly in
position before replacing the oven
shelves.
CAVITY
CENTRE
SIDE PANEL