Filter
Top Products
47
FITTING INTO THE SPACE BETWEEN
CABINETS
IMPORTANT: Ensure that the oven is
switched off at the wall before any further
work is carried out.
· Position the appliance in front of the cabinet.
See Fig. 12.
· Take out all oven furniture before installation to
reduce the weight you need to lift. The oven
door should be taped up to keep it closed.
· To place the appliance into the space between
cabinetry follow the procedure below:
· N.B. Two people will be required to carry out
the lifting procedure.
Warning: Do not attempt to lift this
appliance by the handle(s).
· Each person should squat either side of the
appliance.
· Tilt the appliance so that your hands can support
the underside of the appliance.
· Keeping your back straight, raise the appliance to
the correct height by straightening at the knees.
· Rest the rear underside of the appliance on the
mounting brackets while your hands support the
front.
· The appliance can be pushed fully into the
space. Take care to avoid fouling the mains lead.
· Ensure the appliance is central and level.
· When the appliance is fully housed, screw the
stability screws (supplied with the appliance) into
the underside of the worksurface in the positions
indicated (see Fig. 13), taking care not to distort
the trim. It is advisable to turn each screw
alternatively to avoid damaging the trim.
· Place the heat deflector flush with the edge of the
worksurface, (see Fig.14) with the cork spacers
up over (see Fig.15) and screw into position
using the screws supplied with the appliance.
Failure to do this may cause damage to the
underside of the work surface.
· Replace the plinth board.
· Switch on the appliance and refer the user to the
operating instructions.
Fig.15
WORK TOP
HEATSHIELD
LEVEL WITH
FRONT EDGE
OF WORK TOP
TOP OVEN
DOOR
Fig.14
Fig.13
Fig. 12