Filter
Top Products
51
Fig. 25 DESN 512400 A
Fig. 24 DESN 512407 B
B. TO REMOVE SIDE PANELS
1. Isolate from electric supply.
2. Proceed as ‘TO REMOVE HOTPLATE CASTINGS’.
3. Lower the cooker onto the rollers by turning the adjusting feet fully counter-clockwise.
NOTE: It may be necessary to disconnect the flexible gas connection to allow the cooker
to be withdraw from between the kitchen units.
4. Roll the cooker slightly forward, unhook the safety chain and disconnect the flexible hose.
5. Remove rear fixing screws (3) and slide side panel back and out.
6. Re-assemble in reverse order.
C. TO REMOVE FACIA CASTINGS
1. Isolate from electric supply.
2. Proceed as ‘TO REMOVE HOTPLATE CASTINGS’.
3. Pull off control knobs.
4. Remove control panel fixing screws (4 per casting) (See Fig. 25). When removing the
screws support the casting.
NOTE: When removing the castings, the oven indicator neons require disconnecting from
the facia, hold the cables at their entry into the neon twist and pull, this will disengage the
neon assembly. Be careful when re-fitting facia castings to position neons and wires
correctly.