Filter
Top Products
SERVICING - WARNING
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
4
Servicing Notes
When servicing or replacing gas carrying
components disconnect from gas before
commencing operation and check appliance is
gas sound after completion. When checking for
gas leaks use a liquid leak detector at all joints
and connections to check for leaks in the
system. Use a product specifically
manufactured for leak detection. Leak testing of
the appliance shall be conducted in accordance
to the manufacturer’s instructions.
CAUTION: DO NOT USE A FLAME
TO CHECK FOR GAS LEAKS.
Do not use re-conditioned or unauthorised gas
controls.
Disconnect from electricity supply before
commencing servicing, particularly before
removing any of the following: control panel,
side panels, cooktop tray, or any of the
electrical components or cover boxes. Before
electrical reconnection make sure the range is
electrically safe.
1. To Remove the Hand Rail
Remove the handrail plastic blanking plugs and
remove the 2 end bracket fixing screws.
2. To Remove Control Panel
Disconnect from electricity supply.
Pull off all the control knobs. Remove the hand
rail (see 2) Remove the 2 cross headed screws
that were hidden by the hand rail end brackets.
Open the broiler door and R H oven door and
remove the 2 screws underneath the control
panel.
Pull the control panel forward and support so
that the wires are not strained.
Reassemble in reverse order. When replacing
leads refer to the wiring diagram. Check
operation of timer, ignition, and oven light
switches.
3. To Remove the Cooktop
Disconnect from electricity supply.
Remove the grates, cooktop burner caps and
tops. If there are screws holding the cooktop
burners to the cooktop, remove them (not the
spark electrode fixing screws).
A Cooktop front fixing screws
B Cooktop rear fixing screws
Remove the 2 rear cooktop fixing screws (B)
and the 4 front cooktop fixing screws (A).
Remove the screws holding the flue grille stays
and if the rear extenstion is fitted remove the
screws holding that as well.
Lift the cooktop clear of the appliance. Replace
in reverse order.
Reassemble in reverse order ensuring that the
leads are reconnected. When replacing the
cooktop take care not to damage the ignition
electrodes
Check for correct burner operation.