Filter
Top Products
5
SERVICING - WARNING
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
4. To Remove a Side Panel
Disconnect from electricity supply.
Remove control panel (see 2). Pull the cooker
forward. Remove the 4 retaining screws for
each panel (2 at the front and 2 at the rear). The
lower front retaining screws (one each side) are
situated beneath the lower edge at the front
corners of the side panels
Reassemble in reverse order.
5. To Remove Oven Light Switch
Remove control panel (see 2).
NB The old switch may be destroyed during
removal.
Remove switch button and old switch from its
bezel by gripping the switch body behind the
control panel and twisting sharply.
The switch bezel can then be removed by
folding back its locking wings and pushing
forward. Fit the new bezel to the control panel
by first lining up the raised key on its body with
the cutout in the control panel and pushing it in
from the front. Assemble the new switch to the
bezel by lining up the key sections and pushing
home. Fit the new button by pushing in from the
front.
Replace control panel in reverse order and test
for correct operation.
6. To Remove Electronic Timer
Disconnect from electricity supply.
Pull off the timer control buttons and remove the
control panel (See 2). Remove the timer/
mounting bracket assembly from the control
panel by removing the two fixing screws.
Remove the timer from its mounting bracket by
depressing the plastic lugs on the timer case, at
the same time pulling the unit forward.
Reassemble in reverse order. When replacing
leads refer to the wiring diagram. Check
operation of timer.
7. To Remove A Thermostat
Remove control panel (see 2) and cooktop (see
3). Open the appropriate oven door and remove
the oven shelves.
RH oven
Remove oven roof. Remove the two fixings that
secure the thermostat phial cover. Unclip the
thermostat phial from the clips in the oven back
panel & remove from the top rear of the oven.
LH oven
Remove the two screws holding the thermostat
phial to the oven fan cover at the rear of the
oven. Pull the unit forward to access the rear of
the cooker. Remove both rear cover boxes by
removing the fixing screws and lifting clear.
Feed the thermostat capillary clear of the oven.
Disconnect the wires from the thermostat and
undo the two fixings that secure the control to
the mounting plate. Fit the replacement and re-
assemble in reverse order. Ensure that the phial
is clipped to the oven rear, positioned centrally
between the clips. Check that the thermostat
functions correctly.
8. To Change Broiler Controller
Remove the control panel (see 2) and cooktop
(see 3). Disconnect wiring from controller.
Remove 2 screws holding switch/controller to
mounting panel. Fit new controller and
reassemble in reverse order. Check for correct
operation.
BEFORE SERVICING ANY GAS CARRYING
COMPONENTS TURN OFF GAS SUPPLY.
9. To Change Cooktop Control Valve
Remove the cooktop top, see 3. Undo the nut at
rear of the valve and remove the screw(s)
securing valve to gas rail. Remove old valve,
discard old gasket/seal. Fit new gasket/seal to
new valve.
Reassemble in reverse order. Check valve is
adjusted for correct gas. Check range is gas
sound.