Filter
Top Products
1. An identification tag is permanently mounted on
the cabinet.
2. Plug cabinet into a properly grounded receptacle
ONLY, positioning the unit so the power supply
cord is easily accessible in case of an emergency.
Arcing will occur when connecting or
disconnecting the unit unless all controls are in
the “OFF” position.
3. If necessary, a proper receptacle or outlet con-
figuration as required for this unit, must be
installed by a licensed electrician in accordance
with applicable, local electrical codes.
230V:
To prevent an electrical shock hazard between the
appliance and other appliances or metal parts in
close vicinity, an equalization-bonding stud is
provided. An equalization bonding lead must be
connected to this stud and the other appliances /
metal parts to provide sufficient protection against
potential difference. The terminal is marked with
the following symbol.
NOTE: The appliance must be connected to an
electrical circuit that is protected by an external
GFCI outlet.
ELECTRICAL - 500-1DN; 500-2DN; 500-3DN
VOLTAGE PHASE CYCLE/HZ AMPS kW
120 1 60 LOW 4.0 0.5
HIGH 8.5 1.05
at 208 1 50/60 3.8 0.8
at 240 1 50/60 4.4 1.05
230 1 50/60 4.2 0.97
ELECTRICAL - 500-1D; 500-2D; 500-3D
VOLTAGE PHASE CYCLE/HZ AMPS kW
120 1 60 LOW 4.0 0.5
HIGH 8.5 1.05
at 208 1 50/60 3.8 0.8
at 240 1 50/60 4.4 1.05
230 1 50/60 4.2 0.97
Drawer Warmer Installation/Operation/Service Manual • 7.
I N S TA L L AT I O N
E L E C T R I C A L
NEMA 5-15P
15A, 125V PLUG
NEMA
6-15P
15A, 250V PLUG
FOR USA ONLY
CEE
7/7,
220-230V PLUG
NEMA 5-15P
15A, 125V PLUG
NEMA
6-15P
15A, 250V PLUG
FOR USA ONLY
CEE
7/7,
220-230V PLUG
D A N G E R
ELECTRICAL CONNECTIONS MUST
BE MADE BY A QUALIFIED SERVICE
TECHNICIAN IN ACCORDANCE WITH
APPLICABLE ELECTRICAL CODES.
D A N G E R
ENSURE POWER SOURCE
MATCHES VOLTAGE STAMPED
ON APPLIANCE NAMEPLATE.
D A N G E R
T
o avoid electrical shock, this
appliance MUST be adequately
grounded in accordance with local
electrical codes or, in the absence of
local codes, with the current edition
of the National Electrical Code
ANSI/NFPA No. 70. In Canada, all
electrical connections are to be
made in according with CSA C22.1,
Canadian Electrical Code Part 1 or
local codes.
D A N G E R
IMPROPER INSTALLATION,
ALTERATION, ADJUSTMENT,
SERVICE, OR MAINTENANCE COULD
RESULT IN SEVERE INJURY, DEATH
OR CAUSE PROPERTY DAMAGE.
READ THE INSTALLATION,
OPERATING AND MAINTENANCE
INSTRUCTIONS THOROUGHLY
BEFORE INSTALLING OR SERVICING
THIS EQUIPMENT.