Filter
Top Products
O P E R A T I O N
#8405 — QUICKCHILLER INSTALLATION, OPERATION, AND MAINTENANCE
Pg. 13.
The date and time will appear in the display when the
power key is pressed to the O
FF
position. All operating
modes can be initiated when the power key is pressed
to the ON position and SELECT: MODE, PRESETS,
and PROGRAM appears in the display.
To initiate any Quickchiller operating mode, power
must initially start from the O
FF
position or an
operating mode must be halted by pressing the
START/STOP key so that the SELECTION
SCREEN appears on the display.
HOLD TEMP
Starting from the O
FF
position, press the
power key O
N
. The SELECTION
SCREEN will appear on the display. The
compressor will become energized and
will begin to operate if required by the
sensors.
Press the HOLD TEMP key. The display
will indicate the last operator set internal
compartment temperature.
To change the displayed temperature,
press the up or down arrow key to
increase or decrease the temperature
display within the refrigeration storage
parameters of the Hold Temp mode.
N
OTE
: T
HE MODIFIED COMPARTMENT TEMPERATURE IS
N
OT STORED OR SAVED UNTIL THE START
BUTTON IS PRESSED TO BEGIN QUICKCHILLER
OPERATION
.
Press the START/STOP key to begin
operation of the Quickchiller in the
Hold Temp mode.
The display will indicate:
1. The length of time the chiller is
operating in the Hold Temp mode.
2. The temperature set by the operator.
3. The air temperature inside the
chiller compartment.
4. The temperature of all food probes.
WHEN IN THE HOLD TEMP MODE:
Press the UP arrow key to display the maximum sensor temperature achieved during the completed
chill cycle. Press the DOWN arrow key to display the minimum sensor temperature achieved during the
completed chill cycle.
NOTE: NO DISPLAY DATA IS AVAILABLE DURING THE SENSOR STABILIZATION PERIOD CONSISTING OF THE
FIRST TWO MINUTES OF THE INITIAL STARTING CYCLE.
NOTE: With the exception of the QC-3 counter top Quickchiller model, the Alto-Shaam name on the control
panel will illuminate whenever the power key is pressed to the O
N
position.