Filter
Top Products
16
Smoke Control Grill™
Install on right side only.
1. Turn controls to
OFF
position.
2. Remove grill from cartridge.
3. Place drip pan in well.
4. Place end of cartridge into cooktop well with air
shutters facing rear of well. Lower front of cartridge
into well.
5. Place grill grate on cartridge.
Drip pan
Grill
Installing Smoke Control Grill™
Installing Griddle
1. Turn controls to
OFF
position.
2. Install cartridge according to “Installing Smoke
Control Grill™ Cartridge” section.
3. With grease trap toward rear of cooktop, place
griddle pan over of burner.
• To remove griddle cartridge turn all controls to
OFF
and reverse steps above.
Grease Trap
Installing Griddle
Removing Cartridges
1. Turn all controls to
OFF
. Make sure cartridge is
cool.
2. Using tab on front of cartridge, lift up cartridge until
the botttom clears the cooktop.
• Do not lift cartridge too high. Lifting cartridge too
high can cause damage to orifices.
3. Pull cartridge toward the front of cooktop and
carefully lift it out.
Adjusting Surface Burner Low Flame Size
1. Push and turn burner control knob to
LITE
position.
• Burner sparks until turned from
LITE
.
2. Set burner control knob to low setting.
3. Remove burner control knob.
4. While holding valve stem stationary, turn screw in
center of burner control stem until flame is
adjusted.
• Use small blade screwdriver.
5. Replace burner control knob.
6. Turn surface burner control on and off to test burner
flame.
7. If flame is adjusted too low, flame may be easily
extinguished. Flame may be extinguished by drafts,
door opening or closing, heating and cooling vents,
ceiling fans, etc.
Adjustment
screw
Adjusting Surface Burner Low Flame Size