Filter
Top Products
80
www.amctechcorp.com
specified since pci0 will be the network interface. The gateway value must correspond to the IP address of the
system slot pci0, 192.168.7.1.
Thus, different rc files must be configured for each copy of the filesystem, generating a different image to be
loaded for each module. Note that the eth0 and pci0 can be configured manually by typing in the specific
information at the command prompt on the dimmPCI module, but changes will not be retained upon reboot.
Create a combined image of the new kernel and modified filesystem.
cd /opt/<filesystem name>
make clean
make
Then use imagez.bin and run loader on the module to write in the modified filesystem and kernel. Please refer
to the User’s Manual for details on running loader. The dimmPCI module is now configured for communication
with another device.
To streamline development, part of the computer’s hard drive can be made available using NFS. These changes
will occur in the rc file.